Mi-T-M SAFETY VALVE ASSEMBLY Part 68-6005

Description

Mi-T-M SAFETY VALVE ASSEMBLY Part 68-6005

Protect your equipment and your crew from dangerous over-pressurization with a factory-certified OEM Mi-T-M replacement safety relief valve. Also known as a pop-off valve, the safety valve is the ultimate fail-safe for your air compressor or hot water pressure washer. If your primary unloader valve or pressure switch fails, the system will continue to build PSI until something explodes. A genuine OEM Mi-T-M safety valve is strictly calibrated at the factory to open and vent the system the microsecond it exceeds safe operating limits. Relying on cheap aftermarket valves with inaccurate spring tensions can lead to nuisance “popping” at normal pressures, or far worse—a total failure to open during a catastrophic pressure spike.

Key Features & Benefits

• Precision PSI Calibration: Factory-set to the exact blow-off pressure required for your specific Mi-T-M machine. Ensures your equipment operates at maximum capacity without risking a dangerous tank or coil rupture.
• Industrial Construction: Machined from heavy-duty solid brass and stainless steel internal components to resist corrosion, rust, and mineral scale build-up that can cause inferior valves to stick shut.
• Exact-Fit Threading: Features precision-cut NPT (National Pipe Thread) fittings to ensure a flawless, airtight, and watertight seal when threaded into your compressor manifold or hot water heating coil.
• Fail-Safe Reliability: Tested under extreme conditions to guarantee an instant, reliable release of trapped air or high-pressure water when internal limits are breached.

Common Signs of Failure

Safety valves are wear items that degrade over time. You need to replace your safety valve immediately if you notice:

• Premature Venting: The valve “pops” or hisses while the machine is running at its normal, everyday operating pressure.
• Constant Weeping: A slow, continuous leak of air or water from the valve exhaust port, meaning the internal spring or seal has fatigued.
• Corrosion & Seizing: The valve is heavily rusted or crusted with hard water scale, meaning it likely will not open when it actually needs to.

Compatibility

Genuine Mi-T-M safety relief valves are essential components across the industrial lineup, primarily featured on single and two-stage air compressor tanks, as well as the heating coils of hot water pressure washers.

Warning: Safety valves are strictly rated by their maximum PSI and thread size. Installing a valve with a PSI rating higher than your equipment’s factory spec creates a severe explosion hazard. You must rigorously cross-reference your specific equipment model number with your Mi-T-M parts diagram to ensure you order the exact factory-specified valve.

If your safety valve starts leaking or popping frequently, never attempt to fix it by capping it off, plugging it with a bolt, or trying to tighten the internal spring. This bypasses the safety mechanism entirely and turns your compressor tank or heating coil into a literal bomb. If a safety valve is weeping, immediately shut down the machine and replace the valve with a brand-new OEM unit.